37Fermer39
masteriesLe 26/11/2021 à 11:47
Yoshi Noir (./37):
Just to say that I just picked up the parcel at the post office (Hurray for shit opening hours).
I will set it up on Saturday.

Remember:

"How to" procedure:

1- Flash or deploy provided SD card image into an SD/SDHC card
(usually HP laptop SD card readers are not suitable)

2- Insert the SD card into the hard disk unit SD card slot

3- Connect the unpowered hard disk unit, into the ACSI port of
the unpowered Atari ST/E computer

4- Power up the hard disk unit

5- Few seconds after step 4, power up the Atari ST/E computer

6- Hard disk unit, and SD card partition will be usually detected;
due to its a bootable image

7- If the Atari ST/E falls into an empty desktop, perform a reset of the
computer. Normally the system will go to step 6 in these cases.

8- Enjoy!

I think I sent to you the complete "tracking number and additional information" message,

--------------------------------------------------------------

There are 20 already built and tested units!